The Record and Playback Tab

Record and Playback is useful both to the instructor and to the student. The instructor can play back a student session, thereby providing the student valuable feedback on areas to improve and on areas where they already do well.

A recording does not allow restarting a simulation from a given point. To restart a simulation from a given point, see Key Frames.

1. Start new recording
2. Open existing recording
3. Save current recording to file
4. Stop playback; this sets the application mode to what it was before entering playback mode (the simulation is also restored to that point)
5. Loop the playback
6. Jump to start frame
7. Seek reverse
8. Play back; sets the application mode to Playback
9. Record
10. Seek forward
11. Jump to end frame
12. Scrub control
13. Current frame

Before you can use these controls you must have already loaded a content file from The Browser tab. Then you can use these controls to perform several actions:

• Start recording during the simulation
• Stop recording without interrupting the simulation
• Save or load a recorded simulation to or from disk
• Play back recording in a continuous loop
• Pause simulation to play a recorded simulation
• Leave playback and return to simulation